Wireless alarm button RS1-P2
General properties:
Wireless alarm button RS1-P2 consists of transmitter RT1-P2 and receiver RR1-P and is designed for transmission of two signals (alarm and alarm restore) for the distance up to 500 m.
Transmitter RT1-P2
The transmitter RT1-P2 is made in plastic enclosure.
The following items are located on the enclosure of transmitter:
- Antenna.
- Clip for fastening on the belt (not necessarily).
- Two independent buttons (alarms and alarm restore).
- Transmission and battery discharge indicator.
For transmission of signal it is necessary to hold the button pressed longer, than half a second. Thus the indicator of transmission will light. The device will be in transmission mode all the time while the button is being pressed. Therefore, it is not recommended to keep the button pressed longer than three seconds.
Receiver RR1-P
The receiver RR1-P is designed for receiving the information from the transmitter RT1-P2. The receiver is made in plastic enclosure.
The following items are located on the enclosure:
- Antenna wire (black);
- Wire for connecting "+" from
power supply (red);
- Wire for connecting "-" from
power supply (white);
- Wires "output" (dark blue).
Normally-open dry contact and is meant for load current up to 250mА;
- The power supply and message reception
indicator (POWER);
- The reset button (RESET).
By pressing "A" button on the transmitter RT1-P2, the receiver makes active the output (encloses contacts of the relay) and blinks indicator "Power". By pressing "B" button on the transmitter RT1-P2, the receiver returns the output in normally open state and indicator "Power" stops blinking. Pressing "Reset" button on the receiver also put an output in normally open state and indicator "Power" stops blinking.